Approved Products
Cleaning Procedures
Important Safety Reminders
Cleaning Procedure Guidelines
MSDS
Cleaning Schedule
Ecolab Service Report & ProceduresEcolab Posters/Signage
Home
Back to Food Safety Home
Back to SodexoNet Home

Printing Instructions
Walls

Recommended Products:

Preferred Cleaner:
Oasis 133 All Purpose Cleaner

Frequency:
As needed

Procedure:

  1. Place a clean wall-cleaning pad on handle.
  2. Dip pad into solution of Oasis 133 All Purpose Cleaner. Wring pad until it is not dripping.
  3. Apply solution to approximately 10’ by 10’ section of wall surfaces and allow surface to remain wet for one to two minutes.
  4. Wipe up any solution that has dripped onto floor surface.
  5. Wring pad and go back over wall surface areas to remove excess solution and soil.
  6. Move to the next section to be cleaned and repeat steps 3, 4 and 5 until the entire wall is cleaned.
  7. When pad or cleaning solution becomes soiled, replace with clean pad and / or clean solution.
  8. As needed, spot check walls.
© Copyright Ecolab Information